Sensors

Increase the accuracy of atmosphere gas samples The most important aspect of gas sampling is to get a clean, uncontaminated sample. Our CERMET sample tubes (available in 600mm and 1000mm lengths) ensure that no nickel catalyses the atmosphere during sampling, and … Continue reading →

Precision Measurement of Protective Heat Treating Atmospheres According to DOE studies – minimizing combustion air can deliver 35% savings Checking and tuning air/fuel ratios is one of the simplest ways to get maximum efficiency out of fossil fuel fired process … Continue reading →

NEW – MGA6010 now has fully automatic zero and span calibration built in as standard. Just install it and leave it until the span gas bottle runs out. Probe + IR System Automatically adjust CO Factor (COF) COF Limits predetermined … Continue reading →

Portable Hydrogen Analyser Portable nitriding potential (Kn) device used for nitriding and other process gas applications. Replaces labour intensive and potentially inaccurate burette measurements of ammonia concentration. Calculates %DA and Kn Capable of %DA and Kn with manual input of … Continue reading →

PGA3510 with H2, TrueTemp and RR options The SSi PGA3510 range is now the industry standard for verification of carburising and hardening atmospheres Compare oxygen probe readings with PGA3510 3 gas analyser readings to verify probe performance CQI-9 approved carbon … Continue reading →

Portable low range dew point system used for accurate and reliable verification of gases using the latest in sensor technology. Dew Point Measurement Measurement of very low dew points with high accuracy Excellent long term stability Rapid response time with … Continue reading →

Portable Dew Point Analyser – robust and easy to use Measures Moisture Dew Point in Hydrocarbon Fuels Battery Operated – Truly Portable Simple Operation Cell temperature readout Long Life Dielectric Battery Built in sample pump and filters LED Digital Readout … Continue reading →

The Probe Services department can test, do reports for, repair and certify any manufacturers oxygen/carbon probe. Our NADCAP compliant datalogging test-furnace (with the Super Systems 9205) helps to produce a free Probe Report  that gives every customer detailed information about … Continue reading →

Designed for: High Temperature applications Oxygen sensor for combustion control in re-heat furnaces, boilers and incinerators. This in-situ oxygen sensor measures “%” oxygen concentrations directly in the combustion area of high temperature furnaces, boilers and incinerators. They are intrinsically safe, … Continue reading →

Designed for: Applications where an in situ probe is not practical. Specifically designed to control endothermic generators Can be used on rotary and muffle furnaces Uses process heat to reheat the atmosphere sample Integral sample well Sample bleeds off to … Continue reading →

Designed for: High Temperature and High Carbon Environments Installed directly in the furnace atmosphere Patented design delivers accuracy and repeatability mV signal can be used to calculate carbon potential, dew point or oxygen Available with or without integral thermocouples – … Continue reading →

The world’s best-selling SIRO zirconia oxygen/carbon probe. Continue reading →